how do i put speed nut clip on the shaft it will not go on the motor we also purchased the auger hub and that goes on fine but the speed nut will not go? also why do i need 12 nuts? thanks carlie
Answer Carlie, The clip and nut, need to be installed as a single piece, with the nut portion towards you, you need to turn it counterclockwise to install it on the motor shaft. Then install the auger hub(yoke fork) in the same manner. Once both parts are installed, use a pair of pliers and turn the nut / clip clockwise 1/8 or 1/4 turn, so it jams against the back of the auger hub.
How do you remove this clip?
Answer Hello John. This clip slides off the side of the lip it is attached to. They can be tight. You may need to use needle nose pliers 1021K to do this. Hope this helps.