The top piece of the spray arm fell off how do I replace it?
Answer D, You do have to replace the complete assembly WD22X10054 it's manufactured as a "complete" unit. Here are the basics – 1. Remove the lower rack from the dishwasher. 2. Gently pull the tab back on the base spray arm(a smaller flat blade screwdriver is best) and lift the spray arm up and out. Reverse the procedure and make sure you "snap" the spray arm assembly in place.
How to installWD22X10054 Weld spray arm in my Dishwasher Americana RT714730B serial#
Answer Lazydoggs, Here's some help : " To Remove Spray Arm and Fine Filter Assembly: 1. Remove the lower rack from the dishwasher. 2. Gently pull the tab back on the base spray arm and lift the spray arm up and out.3. Remove the 1/4-in. hex-head screw that connects the spray arm base to the fine filter assembly.4. Gently push the same tab in to lift the fine filter assembly up and out. 5. Clean fine filter screen if soil is present. Note: Ensure that the check ball is clean and not blocked. It should move up and down freely. Note: When installing spray arm, make sure the metal bushing is in the spray arm base. Note: When installing fi ne fi lter, make sure the drain port of the fine filter is engaged to the vertical drain port of the sump with check ball in between." Good Luck and Thanks
Does one install this part from inside the diswasher tub or does the unit have to be disasembled from the underside in order to replace this part? Thanks
Answer Hello Joe. To remove the spray arm WD22X10054 on your model number, there is a locking tab you will need to release. Gently pull tab back on base spray arm and lift the spray arm up