I have to change the flapper in my water Dispenser. I know I can but do not see screws to take it apart can you tell where are they located?
Answer Hello Shelly,
Unplug the unit since there is voltage in the area to be serviced. Grasp the bottom of the display and gently pull. This will release it and the control will come out. You will see the screws that hold the rest of the assembly in position at this point.
I can't figure out how the spring goes back on the unit. Can you explain or provide a picture?
When you take the dispenser apart if you are looking to replace the torsion spring on the dispenser lever then the hook end will hook around the lever and then you would rotate the flat piece just a little to allow there to be tension. It will lay flat on the housing of the dispenser.