My oven does not work at all. When I turn the knob I get a code F3. The igniter works on the clean side and burns very brightly. Thanks
Answer Hello Gordi,
You should measure the resistance of the temperature sensor WB21X5301. If the resistance does not read about 1100 ohms at about 70°F replace it. If it reads properly, go to the control board where the sensor plugs in and test the sensor again from this point. If it now reads bad, trace the wiring harness and repair is necessary.
How do I replace part #wb24k10010 (latch switch) on a Kenmore oven?
Answer Hello Bobp. We will need your model number to help you with this. Please post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx