Terminal Block Assembly

Capecodbeachfront for Model Number JBP23 General Electric

Answer Cape, Apparently you're looking for something like this 330031 ? The contacts in the WB17X5051 kit will need to be attached to the wires that enter the receptacle, so you'll need to cut the original wires and install and "crimp" the contacts onnto the wires, then insert them into the receptacle. Thanks and Good Luck 

Cape C. for Model Number GE JBP 23

Answer Hi Cape. Yes , new clips will work great. They will be best soldered if possible. You can use a crimp tool and work as well as long as you only strip enough wire to insert the stripped portion fully into the crimp terminal end. Then use the tool to fold (Crimp) the open end onto the wire correctly. The crimp tool is part # MA-30428. Insulated Female terminals 3/16" is part # TJMA03018-1. Insulated female terminals 1/4" is part # TJMA02588-1. The card is not shown on our breakdown. Was there installation instructions @ this card? Possibly it was only used so the packaging /shipping would "rigid" the package for shipping purposes. Thank You. 

Don Bergherm

Answer Don, Here's some help," 3-wire or 4-wire Plug Connection Four-wire cord is required for mobile homes or where codes do not permit grounding through neutral. 1. Remove access cover from rear of dryer. 2. Use a strain relief and insert end of power cord through power supply hole. 3. Use the three screws from envelope located in the drum to attach the remaining power cord wires to the terminal block as follows: • Red wire or left side wire terminal to “L1” terminal (left side outer terminal.) • Black wire or right side wire terminal to “L2” terminal.(right side outer terminal) • White wire or center terminal to Neutral terminal (center terminal). • 4-wire Plug Only—Remove ground screw and detach ground wire from bulkhead. Attach power cord ground (green) wire to rear bulkhead using ground screw. Attach free ground wire, previously attached with ground screw, with white wire to the neutral (center) terminal on the terminal block." Good Luck and Thanks 

Su

Answer Hello Su. No, there is no wiring instructions with the terminal block WB17X5051, but you will remove the wires from the old terminal block and install them into the new terminal block. There are clips on the terminals you will release to remove the wires from the old block assembly. Hope this helps. 

F. D. for Model Number J BP23 OF3WH

Answer Hello! The manufacture does not offer this part. However, we have a high temp wire available you can use, part number TJMA0514G. Thanks! 

Guest

Answer Hello. Yes, that is a mounting clip. If your model does not use it, then it is ok to be left off. Hope this helps.