How to install thermostat WB21K10136 ?
Answer Hello Jorge. It is necessary to remove the control panel from the
range or rangetop chassis and place it in the service
position to access certain components.
To place the control panel in the service position:
Note: It will be necessary to pull the rangetop
approximately 10 inches out from its installation.
1. Remove left and right side grates, surface
burner knobs, grill and griddle control knobs.
2. On range models:
a. Remove the 2 Phillips-head screws that
attach the griddle control bezel to the
b. Remove the 2 Phillips-head screws that
attach the griddle control to the manifold
bracket. 3. Remove the 2 Phillips-head screws within each
bezel that attach the bezel to the manifold
brackets. 4. Remove the T-15 Torx screws from the bottom
of the control panel. 5. Remove the Phillips-head screw at each front
corner that attaches the front of the side trim to
the control panel. • A ground wire at each end of the panel allows
the panel to be lowered without falling.
• Before lowering, protect the bottom of the front
panel from scratches caused by the lock motor
arm (range models) or front frame edge.
• If the range has a grill, use caution when
lowering the control panel to prevent damage to
the switches mounted at the bottom of the grill
valve. 6. On rangetops, remove the two 1/4-in. hex-head
screws and the Phillips-head screw (on each
side), from the back of the control panel fl ange. 7. Pull the control panel straight out from the
chassis, then carefully lower the control panel
onto a protective, supportive surface.