How is this part removed from the down draft unit? I can't find screws or clips holding it in place.
Answer Mike, Here are some basic instructions for removing the "TOP CAP" trim for your vent system " 1. Raise the snorkel. 2. Turn off the electrical power going to the vent system. 3. Remove the front panel and two filters from the snorkel. 4. To remove the top cap, remove the two flat-head screws from the ends and lift the cap off the snorkel. NOTE: If you are replacing the top cap, remove the rubber o-ring from the plastic grommet and remove the grommet from the top cap." Good Luck and Thanks