I ordered the trim replacement part for the ice and water dispenser. I have had to remove it in pieces. It would not pull off and unsnap the snapping parts broke off and I dont know how to get them out to replace with the new trim.... drill out the plastic pieces ???? they cant be pushed thru help!!!!!!!!!!!!!!!!
Patience S for Model Number hss 251fmdww
Answer Patience, Hopefully, nothing is damaged, but heres how to remove the trim "The dispenser assembly consists of the interface, display board, dispenser shield, and duct door functioning parts. The dispenser interface can be removed to access the display board and the
dispenser shield mounting screws. The interface is held in place by 4 tabs that hold it to the dispenser recess. To remove the interface, it is necessary to grasp the bottom lip of the interface on either side and gently pull it towards you. There are 3 wire harnesses connected to the display board. Note: The interface and display board are replaced as a complete assembly. When assembling, insert top tabs into the top of dispenser recess fi rst, then snap the bottom into place."
I want to replace the cracked trim piece around the ice and water dispenser on my Hotpoint model #HSS251FMD refrigerator. How do I remove the old trim piece? Do I just snap it off from the outside?
L&l for Model Number HSS251FMDWW
Answer Hi I&I. Yes, you will need to put masking tape around the fountian control trim piece. Then you will either use a small putty knife or a small thin blade screwdriver to pop out the rear clips holding it on. The trim piece is part # WR38X10204. Thank you.
The freezer door flapper will not close completely.
Robert H. for Model Number gss25jfmbww
Answer Hello Robert. You will need to check and see if the solenoid assembly WR62X10055 is bad and is sticking on the unit. If so, you will need to replace the solenoid. Hope this helps.