Apparently the part I ordered does not come with instructions - any help on how to install?
Answer 1. Remove the bracket from theprepack located inside the oven,2. Decide whether the bracket will be installed on the right or left side of range . If the bracket side of the range is adjacent to a cabinet, place the bracket against back wall and cabinet as shown in. If there is no adjacent cabinet,determine where the location of the range side (painted outsidepanel) will be. Place the bracket with its outside edge at this location and against back wall. 4. Determine whether you will anchorthe bracket to the floor or wall. Make sure this location is clear of electrical wiring or plumbing. 5.Fasten the bracket securely with the screws provided. Screws are self-drilling in wood, plywood, particle and chip board, and most metal framing. If attaching masonry, you can buy suitable screws and anchors at hardware
stores. Use a masonry drill to drill the required holes. 6. Using the wrench, back out the four leg levelers at least two turns. 7. Slide the range into place, Be sure rear leg leveler fully engages the slot in the bracket, If range cannot be moved back far enough for rear leg leveler to enter bracket, move bracket forward as required and attach to floor in new location. For the universal chain type refer to pg 29 on the link. Hope this helps! http://genet.geappliances.com/DocSearch/Dispatcher?REQUEST=ShowPDF&FileName=39-4713.PDF