GE WD15X10014 Valve Water Inlet - AppliancePartsPros.com

Total
$0.00

Part Number:	AP5632416
MFG Part Number:	WD15X10014
Made by:	GE

Our Price
$12.47
Regularly	You Save
~~$17.34~~	$4.87

Our GE dishwasher seems like it doesn't fill up with enough water. It will go through the cycles with very low water level. I have checked water pressure, supply line and water valve. They seems to be ok. The dishwasher will run before it fills up enough with water. Is this normal for a GE dishwasher of this model? Or could there be a problem with something else? Thank you Bob G.

Rgalbreath for Model Number GE Dishwasher- GSD2300R00WW

Answer Hello rgalbreath. It sounds like the water valve is bad and will need to be replaced on the unit.

Was this helpful?

Yes

Dishwater detergent has not been completely dissolved.

Theresa T for Model Number Pdw928onooss

Answer Theresa, You will want to make sure that you are running your hot water at your sink before turning on the dishwasher and run unit on hi temp wash. If the water temperature is not hot enough then the detergent will not dissolve or activate.

Was this helpful?

Yes

Does the water inlet valve determine how much water comes into the dishwasher during each cycle or is there something else that actually determines the water level? I am having a problem with my mid and upper arms spraying and cleaning. I have checked and cleaned out my sump and filters. I have noticed from other posts that if there isn't enough water in the sump, the pump will not have enough water to pump through the manifold to the upper arms. I have manually added approximately 12 cups of additional water during the cycles to see if this would help and it has. All the arms are turning with excellent pressure. I am trying to figure out if the inlet valve is not letting enough water in or if something else is restricting the water flow. The water shut off valve is completely open. I should probably ask how much water should this model have to adequately function? The water level is at the same height or just below the coarse screen when the arms don't turn. When I add an additional 1/2 - 3/4 of inch of water, it works great. The dishwasher is only 2 1/2 years old.

Tom for Model Number PDWT400R10BB

Answer Hi. The water amount is directed by the float stem activating the neutral feed to the float switch part # 99002560. Inspect the float stem part # WD12X10048 for damage and replace as necessary. Make sure you have inspected and cleaned all inner tub sump covers and traps down under them for correct pressure. Remove the wash arms and clean with a pick tool under the sink all the jet holes and rinse out the debris. Thank You.

Was this helpful?

Yes

Valve Water Inlet

Questions & Answers

Appliance Compatibility Tool

Repair Help

Questions & Answers

Most Interesting

Latest Questions

Cross Reference and Model Information