I cannot remove Wire Harness From Washer water inlet Valve WH13X10006. It does not side off. I have tried to pull hard. Is there a trick to this model or a special tool?
Answer Hello Jennifer,
If you cannot pull it off by hand, put a screwdriver in the center and use leverage to pop it off. You could also grab the plastic connector with a pair of pliers and pull it off. All three of these will come off with ample pressure applied. The catches are in place to prevent the wires from coming off from the vibration of normal operation of the machine.
Ok re: my issue about the water levels not working with my washer, you are telling me to disconnect the press. Switch hose From the switch and blow and if you hear a click then it's the main board that needs to be replaced ? Wil
Answer Hello Wil. No, Spin all the water out of the tub. Then remove the hose from the switch and blow though the hose to remove any water out of the air dome on the side of the tub. Try running the washer and see if it operates properly. if not, you may have a bad air dome on the unit and will need to replace the outer tub WH45X10111 to repair the issue with the unit. Only reason for replacing the control board is if all the other has been done. You do not blow into the pressure switch, you remove the hose from the pressure switch and blow into the air dome assembly.