How do I assemble the inside of the timer?
Answer Hello John,
Since no parts are available for the timer individually, it is not considered a serviceable part. I'm sorry but there are no instructions for the dis/re-assembly of an unserviceable part.
Washer will fill out but not go into any other cycle.
Answer Hello Jolyn. You need to check the lid switch assembly WH12X1043 and see if it is bad and needs to be replaced. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
My washer just decided to stop cycling through the different cycles. I watched a few videos on how to replace the timer. Would I be correct in saying that the timer is bad? I didn't open up the timer to view the inside of it.
Answer Hello Iceberg,
You will need to do some troubleshooting before replacing the timer. You see, certain things have to happen before the timer motor is energized so it can advance in the cycle. You should pull the tech sheet and remove the main front of the unit. The green LED under the motor board cover will be flashing. Count the number of flashes and this will normally point you to the troubled component by using the scale on the tech sheet. The tech sheet will be inside the control panel.