Washing machine will fill on the wash cycle, but not on the rinse cycle. Tried hot and cold water still the same.
Answer Hello Ward. Usually on the rinse, it only uses cold water. You need to check and see if the water valve is bad and needs to be replaced.
Machine will toss the clothes a couple of times, Then it will fill with some water. It will toss the clothes again, then stop. Then the water empties. This all happens in about 6 minutes.
Based on the information provided it sounds like the control board would be a fault. You will want to put the unit into a service diagnostic mode, this information can be located on the tech sheet which is located inside the unit. See if there are any error codes stored. This will give you a starting point as to what is wrong if there are any stored codes.
This washer will not spin out ,it will pump out the water. Don't know how old this one is .....
You will need to access the tech sheet which will be located in the control panel of the unit. Once you have it you will then need to access the motor. The motor will have a inverter board on it that you will need to check the light that is flashing on it for an error code. The error code chart is on the tech sheet.