My right side door lock broke off. I wanted to confirm that the part I need is LG 4430JJ2005A. Is this difficult to replace? it snapped off.
This cam shaft 4430JJ2005A is screwed to the top of the flange that holds the side of the door gasket. You may not be able to just replace this. There is a trim on the inner corner of the door in which you would grab from the bottom and work your way up to get this trim cover off. Once off there is a plastic piece that holds the door gasket, this is most likely what will be needed to be replaced on your unit.
I NEED TO LIMIT THE SWING ON ONE DOOR TO 90 DEGREES
IS THIS POSSIBLE?
Unfortunately there is no way to limit the swing of the door to 90 degrees.
How to install the Cam Shaft, Part # 4430JJ2005A? Mine broke off on the right-side door.
Also, is it connected to another part in the door that I need to order?
Answer Hello Jeff. The cam shaft part # 4430JJ2005A slides into the center divider holder. To remove the cover you will start from the bottom and pop each clip out as you move up the cover. You will need to replace the lower one also part # is 4430JJ2005B. Unless the top and bottom corners of the gasket is... more not sealing, then you normally do not need to replace a gasket. The inner magnet inside the gaskets onlt go close to the actual corners anyway. As londg as they are close. Also you can use a hair dryer to heat a putty knife to lightly "persuade' the gasket back into place.