Error code DH. Replaced the defrost censor with model suggested by this sight. Did a check on the heater coil and it is good. Did the test on the main board and after that the fridge worked for 3 weeks the then back to the same error code. What's going on?
The Er DH error code is a poor defrost error. It is indicating that Even though it is passed 1 hour since then defrosting, if the defrosting sensor is not over 46 degrees it will cause the error. The things that can cause this would be a faulty temperature fuse, heater failure, drain that is clogged or a poor relay for the heater. With the heater already being tested and it checked good for continuity and the sensor being new, this issue would most likely be caused by a faulty control board.
Error code: er dh
Already replaced main board what is next to check...thanks
The ER DH is an indicator that the defrost heater or the defrost controller have failed on the unit. You will want to do a continuity test on the evaporator defrost heater 5300JK1005D to make sure that it is good and if it checks ok then the defrost controller 6615JB2005H is faulty and would need to be replaced.
The water and ice have stopped working the error code on the front of the freezer say er dh. What part do I need and where is it located? Please...
You will want to check the defrost heater for continuity. The ER DH is a defrost heater error. If the defrost heater which is located in the freezer compartment behind the freezer wall. It will be at the bottom of the evaporator. If the defrost heater has continuity they the main control board located at the top of the unit will need to be replaced.