What size orifices do I need for the gas burners on this range? I am converting from propane to natural gas.
Answer Hello Ken,
This units' orifices are not available alone. The orifice holders have to be ordered to get the orifices. The manufacturer assumes that when the unit is changed over from natural to LP the natural orifices will be saved for future use. The part numbers are as follows:
7527P023-60 BASE, BURNER (5K BTU) TWO of these,
74007961 BASE, BURNER (9.2K BTU),
7527P021-60 ORIFICE HOLDER (16K BTU),
7527P028-60 BURNER HEAD (12K BTU).
Just in case the screws require replacing, the part number for these are 3368921 Orifice Mounting Screws. You will need to remove the cap on the regulator and flip the small attachment under it and re-install the cap. Be sure the washer is in position and check for leaks with a soapy water mixture, (one teaspoon liquid soap in a quart of water). Too much soap in the mixture will not show a leak that may be present.
I have an LG gas dryer. I got it used from my sister. When I hooked it up and started it I smelled gas. Evidently the glowplug did not ignite the gas. I am wondering which parts to replace first ?
You will need to test the thermostats and the flame sensor and make sure they are good. They should read closed for continuity. Also, check the igniter and make sure it is getting hot enough to light the gas. If the igniter is not glowing then check to make sure that it is getting 120 vac across the leads. If it is then you would need to replace the igniter. Here is a link on how to use a multi-meter for the testing procedures. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html