LG EBR36858801 Pcb Assembly,main - AppliancePartsPros.com

Total
$0.00

Part Number:	AP4451021
MFG Part Number:	EBR36858801
Made by:	LG

Our Price
$123.97
Regularly	You Save
~~$147.52~~	$23.55

Most Interesting

I need a help with the dryer outlet. I made the change to 4-pin socket for electric power at 220V. I put a 32-amp dedicated breaker. Unfortunately I forgot to make the switch from electric scheme in the dryer 3-pin to 4-pin socket and plugged in to take the test and departed the power button and did not call. I remembered that he had not altered electric scheme and made the change. The dryer is not turning. With this failure which may have damaged parts?

Alex P for Model Number Dryer DLE5955G

Answer Alex, Once you correct the wiring on the unit if it still not working then you more than likely shorted a thermal fuse or possibly the control board.

Was this helpful?

We have 2 issues: 1) For the past year our dryer drum would turn constantly if the dryer door was closed and the dryer was plugged in - EVEN if it WAS NOT turned on. The only way to get the dryer drum to stop turning was to open the dryer door. 2) NOW - the drum wont turn. We turn it on - set the cycle - hit start - makes a noise and then nothing.

Tyler for Model Number LG DLE5955W

Answer Hello Tyler. If there is no power to the motor, order part number EBR36858901. If there is power, and the motor does not run, replace the motor. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html

Was this helpful?

Nothing happens when you press the power button, light come on when you open the door. Have checked the power source everything is ok there. Looking at the control board the resitor near the connector coming from the power switch has some black liquid coming out of the end it is also under the clear coating

Don for Model Number dle2301w

Answer Don, You're needing a new control board, but you probably realized that. Any damaged to a control board or any component on the board will require a replacement. The oozing liquid, would indicate the voltage capacitor has failed, and that's usually due to some type of voltage "spike", or ongoing electrical power supply issue. The damaged component would explain why the light works, but the control won't . Thanks and Good Luck

Was this helpful?

Latest Questions

I have used this dryier for over 2.5 years and the problem just started last weekend. When I push the power button nothing happens. The light inside goes on when the door is open, but none of the buttons on the control pannel makes any difference. Since there are 2 control boards in the unit, I am not sure if one of them is malfunctioning. Any ideas are greatly appreciated.

Anton for Model Number DLE2301W

Answer Hi Anton. Remove the power. Remove the top by removing the three T-20 torque screws on the back of the cover . Slide the top back and up to remove it. Look at the incoming wires and see if they are all clean and tight at the terminal block. I would use a volt/ohm meter part # TJMA-DM1 to assist. you in your diagnosis. You need 240 vac to the outer 2 of the terminal block and 120 vac from each end to the middle neutral terminal. Use the Supplied tech. diagnostic sheet to put the unit in a diagnostic mode to find the direct fault code. After you find a code then we can help decipher a part needed. Thank You.

Was this helpful?

Pcb Assembly,main

Questions & Answers

Appliance Compatibility Tool

Repair Help

Questions & Answers

Most Interesting

Latest Questions

Cross Reference and Model Information