Solenoid, Reversin, Valve

Jim B for Model Number LMX25985

Answer Hello Jim, Where the water valve is located on unit is when you open the left refrigerator door. Remove the lowest shelf from unit on door. Behind shelf there is a phillips screw that you remove and then remove the cover over the water valve and water tank. Disconnect and replace water valve. You will want to make sure that the water valve is getting power before replacing and this will ensure that it is not a icemaker issue. 

John for Model Number LG LFX 25980st

Answer Hello John, To replace the solenoid on unit you will need to remove the dispenser panel. Remove the dispenser tray and lock the dispenser. Pull at the base of the dispenser and pop the panel out. Once out you should be able to access the solenoid. 

Steve for Model Number LFX25960ST

Answer Steve, We believe your looking for the water inlet valve AJU72992601 and 5220JB2008A located on the back of the fridge, so you'll need to move it out enough to get in back of the unit. Your water tank is located in the refrigerator compartment, behind the crisper drawers, If the reservoir was frozen, you'd most likely have an issue with articles in the crisper drawers freezing as well. Thanks and Good Luck 

Gord for Model Number LFX25960ST

Answer Hi Gord. Make sure the fill tube to the ice maker is not frozen. Have you tried to toggle the I/M switch on and off again ? Ice maker part # AEQ36756901. Is the bottom paddle stuck in the in position or bent ? Feel the ejector blades to see if there is a stuck cube in the tray. It will block the cycle. Is the temperature around 0° and not colder? Check with a thermometer in the middle of the freezer . I would use a volt/ohm meter part # TJMA-DM1 to assist. you in your diagnosis. Place the ice maker part # in a forced fill. Have your meter already placed in the water valve connector to see if the water valve will get the 7 seconds of water fill voltage... TEST MODE Press and hold the cube size button for more than three seconds to put the ice maker into test mode. The test cycle can be used to diagnose ice maker issues and to clean it. Is there any green led lights on in the ice maker indicator lights ? Let us know how they are configured ? Are there any codes showing at the fountain control ? Thank You. 

Rich for Model Number LFX25971

Answer Hi Rich. Yes, if the solenoid does not have continuity, the coils internally are open and not allowing the plunger to be activated. It is part # 6421JB2002P. If you are not getting 120 vac to the solenoid then you need to check for a bad wire connection at the fountain control board part 6871JB2061C and the wires in between both devices. Thank You. 

Trent for Model Number LG LFX25975SB

Answer Hello Trent. To access the solenoid assembly 6421JB2002P on the dispenser, 1) Loosen the screw on the sub PWB. 2) Pull the sub PWB down. 3) Disconnect the wire harness and replace the sub PWB in the reverse order of removal. Pull up and out on the dispenser cover to remove. Disconnect the wire harness. Remove the funnel. You can now access and replace the solenoid. Hope this helps.