Was getting intermittent LE error. 1 every 2-3 months. power off for 30 minutes, spin the drum clockwise, then counter clockwise would fix it. now was 3 times in 1 week. ordered, and installed hall sensor. still getting error. Drum spins by hand with no resistance. Stater and rotor looked good when hall sensor changed. Are there some tests that I can do to narrow down defective component ?
washer is 10 years old.
The LE is a locked rotor error in which you will want to do the following.
• The connector (3-pin, male, white) in the MOTOR
HARNESS is not connected to the connector
(3-pin, female, white) of STATOR ASSEMBLY.
• The electric contact between the connectors
(3-pin, male, white) in the MOTOR HARNESS
and 4-pin, female, white connector in the MAIN PWB
is bad or unstable.
• The MOTOR HARNESS between the STATOR
ASSEMBLY and MAIN PWB ASSEMBLY is cut (open
• The hall sensor is out of order/defective