Hot water slowly dripped into washer tub (1 gallon in a couple of days)
Robert M. • Northridge, CA • July 28, 2014
Appliance: Model KENMORE 110 45992 400
My Repair & Advice
I unplugged the machine. I removed the two fill hoses. I removed the top of the washer case by removing 3 tamper proof screws from the back ( I used my set of "star" head drivers), sliding the top back 1 inch and lifting the top off. I marked the 4 wires with 1 thru 4 stripes with a marker for ID, then pulled the 4 wires off the landing terminals. I removed the mounting screw and lifted the valve up as far as the hose permitted to get a better grip on the valve and hose. I removed the clear hose by squeezing the hose clamp with my pliers and pulling (this was not easy, and I pulled and twisted them really hard). I threw the old one in the trash so as to not confuse it with the new one. They looked identical. I connected the hose to the new valve by squeezing the hose clamp with my pliers and sliding it on. Unlike removing the old one, it went one easily. Then I put the valve where it belonged and attempted to reinstall the mounting screw. It did not line up. I needed to use a rat tail file and extend the hole a little closer to the valve body (five minutes took care of this). I placed the valve body firmly against the sheet metal back of the machine and installed the screw. I slid the wires back onto the terminal connectors (1 - 4, the way I labelled them). I connected the hot and cold water hoses. I turned the hot and cold water on and checked for leaks. I plugged the machine in (don"t get shocked on electrical parts inside the machine). I started a wash cycle and waited for the tub to start to fill with water. I again checked for leaks where the clear hose connected to the valve. I had no leaks and the valves were allowing water to flow. The water stopped as soon as I shut the machine off. I reinstalled the top of the case using the 3 screws and I was done. Next day I checked the washer tub and it was dry. Problem solved. Except for pulling the hose off the valve and extending the hole with a file, everything went easily. p.s. Do not cross the hot and cold water hoses like I did. I lost all my atta boy points after my wife did several loads of laundry in hot water when she wanted cold water only. Bob the investor.
People found this story helpful
Repair Time Estimate