Large Wire Nut (10/PKG.)

Note: This question is for the older version of this part, but we thought you might still find it helpful

Donald R

Answer Hello Donald. This is the correct wire nuts for your install. Hope this helps. 

1 person found this answer helpful.

Rosie C for Model Number ss63gper-2. or ss630per-2

Answer Hello Rosie. Based on the model number you provided, 786324 is the correct igniter. 

Note: This question is for the older version of this part, but we thought you might still find it helpful

Jennifer for Model Number AP2020569

Answer Hello Jennifer. No, TJMA01164C-2 is the small wire nuts that come with the igniter and TJMA01166-1 are the large wire nuts. Hope this helps. 

Note: This question is for the older version of this part, but we thought you might still find it helpful

Roger

Answer Hello Roger! The ignitor can still glow, but not ignite if it is bad. It seems you may have a bad ignitor 786324. You can test the ignitor with an AMP Clamp meter, it should read 3.2-3.6 AMPS when powered on. You can also test it with a volt meter at the wires on the burner valve. It should read 3.2-3.6 AC when powered. If you do not have either of these items available, you can try to visually check it. When an ignitor starts to go out it usually has a dull orange to a red color as when it is new it has a white to bright red color when powered. I hope this helps!