What is the correct control module replacement for this dishwasher?
Answer Steven, the control module listed for your model is part number 00676967. Thanks!
I have a Bosch SHX33A06UC/21 that is rinsing continuously. The water is not hot. Is this a job for the control unit 489004?
If the water is not hot, then you will need to check the heating circuit to make sure that power is going to the heater. If there is no power going to the heater then check the thermistor. If the thermistor checks ok then you will need to replace the control board.
Dishwarsher shows 13 and 1 will not turn off. I found burnt contact on circuit board.
Answer Hello Kenny. Based on the information you provided, it sounds like you will need to order and replace the control board in the unit.
Kitchen Aid Superba Range10 years old. Oven will not light/heat. Broiler and burners work fine. control board lights up and and say "LO" but oven never gets hot.
Answer Hello Bryce,
You will want to check to see if the oven ignitor is working. You do this by testing the amp draw on the ignitor. You should have 3.2 to 3.6 amp draw. If you do not have within this range then the ignitor is bad and will need to be replaced. You will also want to do a voltage test at the control board from connector P2 to Neutral for 120 vac to make sure that control is sending power to the ignitor.
10 year old Bosch dishwasher won't stop washing. Keeps going for hours until I cancel cycle and drain. Is this a simple repair or should I just buy a new d/w? Is repair cost effective for 10 year old dishwasher?
Answer Hello Bryce,
You are most likely not hearing the circulating pump, but the drain pump. If you remove the water valve you can use the opening to check for water in the base. Most of the time on this design, the water valve isn't opening all of the way and a dribble of water into the base has activated the flood switch. In this case, the water valve 00425458 replacement and drying the water from around the flood switch float will correct the situation.
Hi, My dishwasher does not turn off when the door is opened.
Answer Hello Phil,
The door latch assembly 00419828 will require replacement to restore normal operation.
The unit is not working, and all the lights are on.
Answer Hello David. Check and see if the latch 00419828 is bad and needs to be replaced in the unit.