I have a Thermador SC301TP single 30" wall oven, my broil element has a hole in it, I believe the part # is AP2826719, is this correct and can you guide me on how to remove the old one and how to install the new one- Thanks
Answer Hello Bryan. Yes, this is the broil element for your oven. You will need to disconnect the power going to it and remove the screws holding it into place. Then pull out on the old element and unplug the wires. Reinstall with the new element in reverse order. Hope this helps.
1 person found this answer helpful.
I bought the broil heat element and replaced it. This was very easy. After getting installed, the element new element did not work so I checked to see if I was getting power to the element with my meter. I am getting power. Could it be a bad element? Looked it over really close no breaks looks great so what should I check next.
If you are getting 240 vac to the element but it is still not coming on, the issue will be with a bad element. Make sure that when you check the voltage that you disconnect one of the wires from the element and check for 120 vac from the wire that you disconnect to ground and from the empty terminal to ground. Off each of these you should have 120 vac when the unit is turned to broil. If not then then you will want to trace the side that does not have power back to the source. In most cases it is the control board that is causing the issue.