Can someone please post instructions for mounting brackets for Bosch shu66co2.
Answer Hello Vince. Remove the preinstalled mounting brackets on the top of the dishwasher by using pliers to twist to the side and pull up. Locate the side mounting slots. There is one on either side of the dishwasher about halfway up. Install the mounting brackets by sliding each into a side slot. Bend the bracket flanges up with pliers to prevent them from falling out of the slot. Hope this helps!
Will the 170664 mounting brackets work with my Bosch dishwasher? The Model Number is SHX43P12UC/61 Regards.
Answer Terry, according to your model number the mounting bracket needed for your dishwasher is part number 00619985. This mounting bracket comes one per package and can be used on the top or sides. Thanks.
How do you attach mounting brackets on the front of Bosch dishwasher that have broken and you have granite countertops, we need replacement parts.
Answer Hello Gail,
This unit uses the same mounting brackets on the sides as it does if it is to be mounted to the cabinets. The part number (AP2802354) includes a left and a right. They have two slots on the sides just like the ones on the top that the brackets fit into. Very simple and easy. The dishwasher will have to be slid out at least 3 inches to accomplish the installation of the side brackets.
Will the 170664 mounting brackets work with my Bosch dishwasher?
Answer MJD, the mounting bracket set 00170664 is the correct mounting brackets and will work on your Bosch model SHY56A05UC/23. Thanks!
Is this the correct mounting bracket for the Bosch SHU43C07 UC/17 model? If so, does it come with the screws also? Or is there a different order number for those?
Answer Hello Coleen! Yes, the mounting bracket set 00170664 is the correct kit used for your model SHU43C07 UC/17. This kit does not include screws. The manufacturer does not offer screws in this kit or in the diagrams/part lists for this item. Thanks!
The right side mounting bracket is broken. Although the dishwasher will still work, it seems a little noisier. Is this a result of the broken bracket?
Answer Hello Bill,
Normally, this is not the case. Most of the time when a complaint is made on the operating noise of a dishwasher, there will be debris on the pump. It should be opened and vacuumed out with a wet vac.
The top mounting brackets are broken and the unit is loose. How do I remove the brackets to replace with new ones? Do I need to pull out thre washer? How do I do that?
Answer Hello Bobby,
The brackets 00170664 can be installed on the sides of the unit by pulling it out only about 5 inches. You shouldn't have to disconnect anything to pull it out this small amount unless the electrical or water supply lines are too short. If the brackets on top didn't last long, you might want to put them on the sides. The same brackets can be installed either on the top or on the sides.
The old brackets pry straight put from the top with a flat blade screwdriver.