I need to attach the dishwasher to a cabinet face that is parallel to the side of the dishwasher; can these brackets be bent at a right angle to accomplish that? Thanks for your help, Michael
Answer Hello Michael! It seems you are looking for a side mounting kit. May we have your appliance model number please? Also, are your counters granite? Thanks!
2 people found this answer helpful.
Have installed a marble counter top. Which mounting part is required for side mounting? Thanks.
When you open the door of the dishwasher there will be plugs in the opening on the side. You take the mounting brackets from the top of the unit attach to the side for the side mount. You remove the plugs and put screw into the mounting brackets and into the cabinet. If you need these then the part number for the mount kit would be part number 00422815.
Do I need to cut a slot in the rubber seal in order to side mount the bracket? Otherwise, I do not see how the bracket can be installed on the side.
Answer Hello Mike,
You can cut it if you want since this is not a water seal. This is only a decorative piece to prevent the side of the unit from being visible from the front. The actual door seal that hold water is inside the door and cannot be seen unless the door is opened.
I recently bought some of the side seals for this dishwasher the old ones were connected with brackets the new ones say to screw directly onto the dishwasher. The mounting brackets are all loose where do I re attach them? was reading it said there was a spot half way down on side of dishwasher do you have picture?
Answer George, The 00170664 mounting bracket kit is for securing the dishwasher to the cabinet either at the top or the bracket needs to be modified for a "side mount" installation. If we understand your question, the side trim strip(s) 00740617 are secured to the side of the tub flange / frame by clips 00186929 and then mounted to the frame with screws 00423896. If this information is not correct, please repost your question, and include an e mail address so we can attach installation information if needed
Can someone please post instructions for mounting brackets for Bosch shu66co2.
Answer Hello Vince. Remove the preinstalled mounting brackets on the top of the dishwasher by using pliers to twist to the side and pull up. Locate the side mounting slots. There is one on either side of the dishwasher about halfway up. Install the mounting brackets by sliding each into a side slot. Bend the bracket flanges up with pliers to prevent them from falling out of the slot. Hope this helps!
Will the 170664 mounting brackets work with my Bosch dishwasher? The Model Number is SHX43P12UC/61 Regards.
Answer Terry, according to your model number the mounting bracket needed for your dishwasher is part number 00619985. This mounting bracket comes one per package and can be used on the top or sides. Thanks.
How do you attach mounting brackets on the front of Bosch dishwasher that have broken and you have granite countertops, we need replacement parts.
Answer Hello Gail,
This unit uses the same mounting brackets on the sides as it does if it is to be mounted to the cabinets. The part number (AP2802354) includes a left and a right. They have two slots on the sides just like the ones on the top that the brackets fit into. Very simple and easy. The dishwasher will have to be slid out at least 3 inches to accomplish the installation of the side brackets.