While installing a light bulb, I heard a pop and now the oven beeps but everything still works except the light of course. Any ideas?
Answer Hello Kurt,
This sounds like you may have replaced the bulb with power to the bulb turned on. This can shoot the bulb and/or the power supply for the bulb. Pull the tech sheet for the unit and test for voltage to the bulb. If voltage is present, turn the switch off and change the bulb again. If no voltage is present, try turning the switch on and re-testing. If still no power to the bulb, check for a fuse to the power supply board and voltage to the power supply board.
Less than a month ago, our oven stopped working out of the blue. It turned on and the display worked but it wouldn't heat up. Called repair guy and after checking everything, he replaced the relay board (92028) and showed me the burned out spot. 2 days ago I used it, 350 degrees for a few hours. My husband said he smelled plastic, same as when it stopped working last time. Tried to use it tonight and it won't heat up again. What the heck?! Did I get a bad relay board? Could it be an electrical issue? We've had this oven for 6 years and never had a problem. Thanks.
Answer Hello Elena,
If the same issue has occurred, and I would definitely check first, The issue is normally caused by excessive current flow. I would check in the junction box where the wires are normally wire-nutted together. Many times when a repeat issue occurs, there will be a loose connection. If no problem exists, I would consider replacing the breaker since they are inexpensive to replace, (hold on to the old one in case the problem recurs and it is proven not to be the cause of the issue. If all checks good, replace the board again, (especially if it is still warranted).
Oven starts in all modes but then shuts off. Any ideas as to what is causing this?
Answer Hello Bob,
This is either a bad electrical connection to the unit or in the power supply, (wire nuts in junction box). It could even be a bad breaker. The relay on the power control board could have burned points in it. I would chase the power supply line first. The relay board 92028 will be the issue if the issue isn't in the wiring.
I need to replace the 92028 relay board on my dacor range. I know how to find it but wonder if there are any pre-cautions to take when removing the old board and putting in the new one or is it an easy job to replace? I don't want to get shocked!
Answer Hello Al. Just make sure the power is turned off, and when you remove the old board, you install the wires on the correct location on the new board 92028. Use tape and mark the wires to the terminals they are on for installing them onto the new board. Hope this helps.