The belt keeps coming off the large pulley.
Answer Hello Mike. The bearing is bad and you will need to replace the outer tub assembly 131525500.
Will not spin out.
Answer Hello Bob. Check and make sure the lock assembly is good and the pump is working properly and is not clogged. Either will prevent the unit from spinning properly.
Everything else works fine It just will not spin. It fills and drains but does not spin. Yes the door latch works also.
Answer Hello Madeline. If the door lock assembly 131763202 is working, but the wax motor does not send signal to the control, the unit does not spin properly. It sounds like the lock assembly is bad and will need to be replaced. If the unit locks, it can still have a bad wax motor on the unit. Hope this helps.
The washer after an unbalanced spin will not spin anymore. It works the other cycles but does not spin.
Answer Hi Madeline. Is the door switch locking and staying latched? If not it will cause this issue, part # 131763202. Is the pump clear ? Part # 131763202. Are the shocks OK? part # 134564200. Thank You.
How do you tighten a loose belt?
Answer Hi Kelly! This answer was located on our Repair Forum, this is a free service in which technicians will assist with answering repair questions for our customers. Please use this link to assist in your repair: http://forum.appliancepartspros.com/washer-repair/46542-frigidaire-washer-belt-rips-shreds.html . Hope this helps!