The number 82 shows on display when trying to start a load. Then it does nothing. Ideas?
Normally the 82 would indicate length of time that the unit has to run. You will want to check to make sure that there is power getting to the water valve and make sure that the float is not stuck and that the float switch is good.
I just purchased the latch assembly from you and put it in a few minutes ago. It fixed the CL code. Everything shows normal like it is running, but nothing is happening. Is this my board?
Answer Hello Samuel,
If the connections are all on the control tightly, you should make sure the unit is sitting on all four feet. If one foot is off the floor, this can put a warp in the tub that will prevent the door switch from making contact with the door latch. This will prevent the operation of the machine since the unit thinks the door is open.
My dishwasher stop working. None of the buttons do anything, but if u turn the power off then back on pf will show up in the display then does nothing.
Answer Hello Rich,
You will want to check your Membrane switch to make sure that the ribbon cable is seated into the control board good and tight. Also check for corrosion and clean with alcohol. If this checks ok then the membrane switch 154639203 would need to be replaced.
Dishwasher does not work. Display reads "ER/CE". Is the problem the control board AP4499574 or the keypad AP4298796? Thank you!
Answer Hello Karen. Based on the code you provided, it sounds like the control board 154757002 is bad and will need to be replaced. The code is for configuration error. Hope this helps.
Can Ireplace the control board or do I need a repair man?
Answer Hi John. Remove power. Open door. Remove all inner door panel door screw. Take off the rinse aid dispensor elect connector and set door aside. Remove latch assy. and control board mount box aside. Then unhook the ribbon cable from the control board to the control panel. Make sure the ribbon cable is pushed in correctly. The part # is 154639203. Thank you.
Dishwasher stopped working. Error Code reads PF on front. Hi Temp Wash and Air Dry lights are blinking on top.
Answer Hello LNK. If the code does not cancle out, you may have a bad control board 154757002. Check and make sure the ribbon cable is clean and dry going to the board. The PF code is for power failure. Hope this helps.