Does the clock/timer control the preheat and oven ignition and gas flow? I just purchased the gas safety valve think that was the cause of the oven not heating up. My installation of the part did not solve the problem.
Answer Hello Mathew. The clock does send power to the igniter. If you have no power to the igniter, you will need to test and see if the clock is sending power to it. If not, replace the clock assembly. Hope this helps.
1 person found this answer helpful.
I need the clock/timer unit for a frigidaire stove model FGF379WECS. Since it is not available are there other options?
Answer Hello Susan,
There are companies out there such as corecentrics that rebuild control boards. You just need to search the web and see if any of them do the board you are needing repaired.
Which part do I need to order if I am getting an F3 code on my display? I cannot control my oven at all
Answer Hello Jayson. You will need to test the temperature sensor 316134900 and make sure it is good in the unit. It should read around 1100 ohms at room temperature and 1650 ohms at 350°. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
Everything works fine but the display is so dim it is barely readable.
Will the AP2125110 fix the problem?
Answer Hello Andrew. Based on the information you provided, it sounds like the clock assembly 316080102 is bad and will need to be replaced. Hope this helps.