Okay. So I replaced the control a second time and the vent door is still open during every cycle except the dry cyle. As I mentioned before I have also replaced the vent switch, blower and gasket. When I run the service test this is the result: 07 - Sensing/Washing, 06 - Sensing/Washing, 05 Washing, 04 - Washing, 03 - Washing, 02 - Washing, 01 - Washing, 01 - Dry, Blank - Dry and then when test completes the Rinsing/Clean lights are on. So it appears it is not cycling for rinse.
Answer Hello Kevin. It sounds like there is a wiring issue with the unit. There should not be 120 volts coming to the actuator during the wash cycle, and not there during the drying cycle. It sounds like the wiring is crossed and is feeding the unit in reverse of what it should be. You will need to check the wiring on the unit.
Installed this part and on drying cycle the vent door remains closed and when done the rinsing light is illuminated. The vent opens during other cycles. I also replaced the vent door gasket and switch to no avail. Could it be a bad control? As I recall the vent door opened during the drying cycle with the original control.
Answer Kevin, We did verify, you orderred the correct control 154362809 based on the model number you supplied. A new "faulty" control is a possibility, But first check and insure you have the new control board and switch wired correctly. The manufacturer may have relocated the terminals and or you may have crossed a couple of wires. Thanks
After installing this part the dishwasher when in drying cycle the vent door doesn't open (opens during other cycles) and when to load is complete the rinsing light is lit. I also replaced the vent switch and gasket thinking that might be the problem. Could it be a bad control?
Answer Hi Kevin. Use a volt/ohm meter part # TJMA-DM1 to assist you in your diagnostics. It will be advantageous to find the supplied tech sheet inside the cabinet to aid you in the diagnosis. It allows you to put the unit in a diagnostic mode which brings up fault codes and tells you which circuit needs assistance. Double check all wiring to the board. Keypad (user interface ) part # 154369701. Display board part # 154393501. The control board is part # 154362809. Thank You.