Dishwasher runs but not lighting up continious, never shuts off, also will run at end of cycle and CLEAN is lighting up..
Gary
Answer Hello Gary. Based on the information you provided, it sounds like the control board is bad and will need to be replaced.
The unit will not pump the water out. All the pump does is make a clicking sound. I took it off and had it tested and its fine. All the connections look good. Where do I go from here?
Matt B for Model Number PLD4375RFC0
Answer Hello Matt. Check and make sure there is no clogs in the unit. If not, and you have tested to verify proper voltage to the pump, but the pump does not run, you will need to order and replace the drain pump assembly 154580301 on the unit. These can test good, but actually be bad. Be sure and verify the voltage coming to the pump and look for clogs before replacing the pump assembly. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
Replaced the control panel and when I switched the power back on the PF lights just flash but the dishwasher doesn't work. What else could it be is there a reset or something?
John W. for Model Number GLD4355RFB3
Answer Hello John. Press the cancel/clear button on the control panel to clear the PF code. If that does not work, and the control panel is new, you need to check and make sure the ribbon cable is installed into the control board properly on the unit. If it is not, you will have issues with the unit not responding to buttons pressed on the unit.
I HAVE AN ERROR CODE : ER U0. I called Frigidaire and was told that is has to do with the vent assembly and not communicating with the control board. Also that one of the cycle buttons may have been pushed one to many times before the cycle can complete. Re: the buttons, they told me to cut electric to the unit for 30 sec. and see if that resets the unit. It did not. I still get the ER UO blinking message. Is this a control board issue and can it be easily replaced?
David for Model Number PLD4375RFC1
Answer Hello David,
For the UO error code you will want to check the wiring between the vent assembly and the main control. If wiring is correct then replace the vent assembly. If the error still exist then it would be the control board. With the ER error code it indicates a failure of the Membrane switch. You would want to check ribbon harness to ensure it is seated properly and that there is no corrosion on the cable. If all checks ok then you would want to replace the Membrance switch. If problem continues replace control board.