my ice door flap ic sticking about half way open .it looks like the torsion spring is fine,would the damper rotary have something to do with this problem?
Answer Hello P. J.
You may want to check to make sure that the pin is in place properly. Also check the gears on ice dispenser lever to make sure that they are not broken. If they are broken then they will hang up causing door to not close properly.
When I push the water dispenser actuator, the water does not come out straight. It just spits out and most of the water misses the cup.
Answer Ray, A couple of things first. Have you recently replaced the water filter WF2CB ? Or had any plumbing work performed. You may have air in the sytem, causing the "sputterring", you could try running the water dispenser until the sputterring stops(3 qts.to 1 gal.) if that's the case.You can also check the crisper drawers and water reservoir, and make sure neither are freezing. Thanks
How can I get water to dispense from dispenser on door?
Answer Hello Jan. Remove the water line from the bottom of the door and press the dispenser to see if any water comes out. If so, the water line in the freezer door is frozen and will need to be thawed out. If there is no water, and the filter is good, you will need to replace the water valve 242252702 on the unit.
Water drips out of water supply in frezer door water dispencer.
Answer Hello Jeff. If you have replaced the filter, you will need to run about 2 gallons of water through the door to clear the air from the water lines. If you have not replaced the filter, you may have a leaking water valve and will need to replace the water valve 242252702. Hope this helps.
My ice door flap is sticking open. What is most likely cause for this? Unit is about 4 years old.
Answer Hello Dan. You will need to check and see if the dispenser torsion spring 241688901 is broke or bad. Also check the flap 241688501 and make sure it is not tore or broke. Hope this helps.