Quit running right before dry cycle after draining. Breaker is good. Does nothing with buttons or control knob.
Answer Hello Alan. You need to check and see if there is power coming to the control board on the unit. If there is power coming to the control board, and the unit does not come on, you will need to order and replace the control board on the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
The latch key is broke im unable to now get the door to open. Have any suggestions?
Answer Hello TC. Lift upward on the handle and door and jerk open to release from the strike. Then disassemble the door and replace the latch assembly.
Is it difficult to change door handle /latch?
Answer Hello Flordia. No, the latch 5304442173 is not hard to replace. You will need to disconnect the power to the unit. Then remove the screws securing the inner door panel. Remove the inner door panel and remove the old latch assembly from the panel and install the new one. Hope this helps.
Just the plastic handle broke. Is that part available by itself? All other parts seem fine.
Answer Hello Scott! Unfortunately, the door handle is only available as a kit with the latch and gasket assembly 5304442173. Thanks.