How to install a belt?
Answer Hello William. First lift the top of the machine by releasing the clips from under the top corners. To install this belt you will need to remove the front assembly of the dryer. Once removed you will need to loop the new belt around the dryer drum. Here is a link to the Repair Forums page. This is a free service we offer our customers. This link has diagrams of how the belt goes around the pulleys. Hope this helps. http://forum.appliancepartspros.com/dryer-repair/25860-dryer-belt-diagrams.html
1 person found this answer helpful.
Hi! My dryer its not drying and a few seconds of runing a the light from control panel turn on and they start flashing. Thank you hope you could help me
Unfortunately the model number listed is not showing as being a valid model. We will need to have this information to be able to assist properly. Please post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx
How do I attach the electric power cord to the dryer?
Answer Hello John. The two hot wires to go each outside terminals on the terminal block and the center terminal on the block is the neutral wire.
Noticed my clothes had a burning smell when I took them out of the dryer yesterday. They were dry and when I ran the dryer with them dry, I noticed nothing, so I assumed the extra pressure of wet clothes had made the belt slip or the motor work too hard and that that was when the burning smell was made. I have the thing apart, and everything turns easily and no wheels are stuck, so I wonder how to guess if it is the belt, motor or something else. The system runs quietly and starts up quickly, except for some squeaks when a heavy load is in there.
Answer Hello Gordon,
Most of the time when a really hot odor is detected it can be traced back to the units' exhaust duct. You see, when the unit pulls in room temperature air, this is used to keep the operating parts cooled to a normal temperature. If the unit is unable to get rid of the heat it will cause the entire unit to run hot and this is when the hot odor is noticed, mechanical parts begin failing, and thermal components begin failing. This sounds like you are in the early stages of this type of failures. You should make sure the ducting is not too long, no crimps or clogs are present, and a good air flow is present at the exhaust outside of the home. Another mistake that is commonly made is when flexible ducting is used, excess is not cut off and 25 feet of flexible ducting is "wadded" up behind the unit. This is practically the same as stopping up the exhaust. Think of it this way, the heat helps to evaporate the moisture so the air flow can more easily carry it away from the clothes. The easier the dryer can get rid of the heated moisture, the faster the clothes get dried.
I need to open this stacked dryer unit first, the answer is about the belt.
Answer Hello l marcus. Disconnect the power, remove the access panel on the front of the unit. Then remove the control panel from the unit. Once removed, you will remove the screws securing the front panel and remove the front panel. Once removed, you can access the belt in the unit.