My upper oven does not heat on broil or bake but convection fan will run. Both elements tests at 22 ohms. The lower oven will bake but not broil. The upper element tests at 22 ohms. What should I look at next ?
Answer Hello Ken,
This sounds like bad relays on the control boards 318022002 and 318022001. I would verify 240Vac to the elements. When you see that the voltage is not present, (I am suspecting you will only find 120Vac), turn th3e power off and remove the wire from the control to the element. Turn the power back on and set to the appropriate setting for the element you are checking and if you are not getting the voltage from the board, it has failed. The same procedure applies to each of the elements.
How to remove lower oven heating element?
Answer Hello Jim. 1. Disconnect wall oven from electrical supply.
2. By the inside of the oven, remove the 2 screws holding
the broil element 318255600.
3. Remove the element from it place by pulling it toward
4. Replace the bake element and reassemble in reverse
order. Hope this helps.