I have a kenmore glass cooktop. I didn't keep note of where each wire goes how can I know where each wire goes??
Not sure of the exact color coding of the wires for your unit due to the manufacturer does not supply wiring information for us. You can look at the wiring diagram that you have and it will have the correct wire colors. It appears that there will be a gray wire that will go to 2b on the little box. There should be numbers on it. 2b will jump between each element. There will be a black wire that will connect to 1b. There should be either 2 brown or 2 orange. One of the wires will come off of the H2 on the burner switch and connect to 2a and the other will connect to the element.
My 3 burners stopped working. How much is for whole set? Is the price listed for 1 or 4 of them?
Answer Marek, the manufacturer does not offer the burners are a kit or set on your model. The 6" element part number is 316010205 and the 8" element part number is 316224200. You'll need to order a QTY of 2 each. Thanks.
I need to replace the heating elements on both burners on the left hand side of the glass cooktop. What parts do I need and how do I install them?
Answer Sam, the left rear element is part number 316010205 and the left front element is part number 316224200. Remove or turn off power to the unit. Remove or open the door. Remove the screws that hold the top to the trim plate. Lift up on the maintop and support the top. Remove screws and wiring, keeping note of where each wire is located at, to the burners. Reassemble in reverse order. Thank you.
I need to replace the limit switch of 316010200, do you sell that part?
The limiter on the element 316224200 does not come as a separate part and you would need to replace the element.
How do I install this heating element part # AP 2126528 on my Frigidaire stove top
In order to replace the heating element on the cooktop you will need to pull the unit from installation. Making sure that power is off. Remove the knobs and you may have to remove screws holding the burners switches if there are any. Once this is done you will remove screws around the perimeter top of the burner box that would hold the main top on. Once screws have been removed lift top off and the element will be exposed to be replaced.