How do I removed the label module cover to replace it with a new one for the ice, and light dispenser on the front of the freezer door?
Answer Hello Bluesapphire,
This simply peels off. You can heat it to make the old one come off easier, Once off, before attempting to apply the new part, clean the old adhesive material from the surface with rubbing alcohol and a paper towel. Once all of the old adhesive is removed and the surface has completely dried, you can carefully stick the new part on being careful to apply it straight, since peeling the new part back off will destroy it.
I took the front cover off the control panel to clean it cannot get it to work again
Answer Hello Rod. Check the connections for a good tight fit. If they are good, replace the dispenser board 241708309.
I need to know what parts to order to get the light to come on in the door ice and water dispenser.
You will want to check the light bulb 5304421616 to make sure that it is not blown. If the light bulb is good then more than likely the faulty part would be the dispenser control board 5304421827.
How do I take the white switch cover off of door?
Answer Hello Rosemary! There does not seem to be any screws that would need to be removed. You will simply peel this off/gently pry out. Thanks.