I can't find what model number my Frigidaire stove is. How can I order an element?
Answer Hello Chris. We will need your model number to help you with this. Please call 1-877-477-7278 or post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx
I have a Frigidaire oven and the bake element is not working is gets very low warm but the broil element is working and the stove top burners are working. Is this just a replacement of the oven bake element that should fix it or could it be the plug outlet voltage because I read another question on this topic. Thank you
Answer Hello Nancy,
If the broil element is turning orange when energized, you have 240Vac to the unit and the problem will be isolated to the bake circuit. This means that you either have a bad bake element  or a bad relay on the control . You can either test the bake element, (be sure to power down the unit since 120Vac rides on one side of the element at all times), or you can test power out of the bake terminal with the wire disconnected from it. This terminal should read 120Vac with the wire off. If it does, the element is likely the cause.
We just replaced the heating element in our electric range buy the oven still won't heat up. There is plenty of juice going into element. What could be wrong?
Answer Hello Jeanett. If there is 240 volts to the element, and the element is good, it should work. However, low voltage will cause a no heat issue or bad wiring. You need to test directly at the element in the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
I ordered the baking element and when I removed the baking element the wire on the right came out so I could install the new element but the left one did not come through the hole How do I get the wire through the hole?
If you cannot get the wire through the opening then you will need to pull the unit out and remove the back panel. If you go ahead and install the bake element then you can just plug the wire into the element once you have the back panel off.
After turning the oven on the main and range breakers blew. After restoring power, the stove top works but no power at all to the oven. Would the oven element be doing this? It is a frigidaire if that helps any.
Answer Hello Retort, I would turn off the breaker to the oven/range and check the oven elements and wiring. Perhaps a wire burned off and shorted causing the breakers to trip. You may need a new element but check the wires too. Hope this helps!
What bake element will work in my oven and will heat at normal temp?
Answer Hello Melissa. Based on the model number you provided, you will need to order 5303051519 to for the correct bake element. You will need this element for the unit to work properly. Hope this helps.
I got a bake element 240 volt from you recently. I don't have the owners manual but in the kenmore parts book it lists both the 208 volt and 240 volt element. Does it matter which is used? Is it safe to install the 240 volt without knowing what the original one was?
Answer Charlotte, The most common power supply for an electric range in a dwelling is 240 VAC. I'm sure you'll be fine with what you have. A 240 VAC element installed in a 208 VAC system will still heat, but take longer to come up to temperature. A 208 element installed in a 240 VAC system will heat, but will deteriorate and quit working sooner than usual. I'm sure you'll be fine. Thanks and good Luck