Oven will heat up one time then it will not heat up again until it has cooled off. I have replaced baking element and temperature probe. What else could cause the problem?
Answer Hello Terry,
If this also affects the surface elements the issue will be a the terminal block where the power cord connects to the unit, the wall outlet, or the breaker in the home breaker box. If the surface is not affected, look for the problem at the electronic control 316207600.
i have replaced the oven sensor probe and I am still getting a F10 code and when I unplug the sensor probe I get a F30 code
Check the wiring from the control board to the sensor to make sure that it is ok. If this checks ok then the control board is faulty and would need to be replaced.
The oven will come on and heat but will not reach operating temperature. I set temperature at 375 oven begin heating but 45 minutes later still not up to temperature but oven was warm
Answer Michael, This is a gas range, Does the broil burner ignite and heat ? if so, you most likely have a weak bake burner igniter 5303935066,weak igniters are the most common issue for temperature problems in a gas oven. if you remove the bottom floor panel in the oven, program a bake cycle and observe the igniter, it should be glowing "white" hot in 60 seconds or less. It should be drawing 3.2 to 3.6 amps at this point. If you can get access to a clamp on amp meter you can verify the draw. if the amps are not reached, the gas valve won't open or becomes intermittent and the ignition process ceases and the oven doesn't reach the selected temperature.