Hello,
I have a Frigidaire Gallery Washing machine, model # FWT44FGES2. It stopped draining. I believe this is the part I need (part # AP2106445), but I am not to sure. Can you please advise to weather this is the part I need or not.
Thank You,
John
John
Answer Yes, with this model it would typically not drain due to a bad pump/motor. The motor itself might burn out, or there might be something stuck inside the pump, like a sock. This is the right pump/motor for FWT445GES2 (the F is a 5). Thanks.
2 people found this answer helpful.
I have a Frigidaire FWX233RES2 that will not drain. I have replaced the drain hose. There are no clogs. The drain pump comes on and the impeller inside the pump spins normally. Could the pump still be the problem?
Spenser for Model Number FWX233res2
Answer Hello Spenser,
If the impeller is damaged then it could be the problem with unit. If the vanes on the impeller are ok then it would be an issue with some type of blockage that is keeping water from flowing. You will want to verify that it is spinning while on, if this is not how you checked. If the impeller spins with power applied then the pump is good.
As others have explained, my washer will not spin. The tub fills, the timer moves but the tub will not move. It does not wash, or spin. The timer goes tru the cycle, tub does not spin. It sucks out the water then it shuts off.
Anthony for Model Number FWTR445RFS0
Answer Hi Anthony. Find the wiring diagram under the top and/ or inside the cabinet folded up in a packet. The wiring diagram we see is too smudged to figure the colors of the wires going to the pressure switch. The tub fills and then the goes connected to the pressure switch is sensing the water fill and pushes the displaced air back up the hose and allow the pressure switch diaprahm to close the contacts and allow the motor to run. You can figure the common terminal (feed) and jumper that wire to the closed (fill) terminal on the pressure switch to see if as thew door is shut and it is on a low fill setting with water then the unit should run. Use a volt/ohm meter part #@ TJMA-DM1 to assist you in your diagnostics. Unhook the pressure switch hose. Blow back into the tub and see if you blew out any restriction. Lint ( a clogged dryer vent system) will get into the hose and not allow proper switch sensing operation. Take another hose the same size and hook it onto the pressure switch. Keep the original one hooked up to the tub taped tight to the back of the controls area so it does not fall and leak while testing. At the point to where you think the timer is set to run with a low water fill and the door closed, blow into the switch. It should close the diaprahm contacts and allow motor to run. If it does not then you need a pressure switch part # 134433701. You can do this procedure instead of the jumper of the wires if desired. Let us know if we can help you further. Thank You.
Hi, can you tell me how many gallons a minute the AP2106445 pumps puts out and at what PSI?
THX
Paul for Model Number fwx6970ew2
Answer Hello Paul. We do not have that information. You will need to contact the manufacture of the pump 131268401 for that information. Thank you.