I removed the water filter by pulling it out. To replace the filter I pushed it in but it will not hold it in . What can I do to get to connect . filter WF3CB
Dan for Model Number Ffhs2611Lqo
Answer Dan,
When you push filter in it should click into place and if it is not clicking into place then you will need to replace the filter head.
How do you change out the water filter?
Joe Z for Model Number ffus2613le4 frigidare
Answer Hello Joe. To replace your PureSource 3TM water filter:
It is not necessary to turn the water supply off to change
the filter. Be ready to wipe up any small amounts of water
released during the filter replacement.
1 Turn Off the ice maker.
2 Remove the filter by pushing on the end/face of the
filter.
3 Slide the old water filter cartridge straight out of the
housing and discard it.
4 Unpackage the new filter cartridge. Using the
alignment guide, slide it gently into the filter housing
until it stops against the snap-in connector at the
back of the housing.
5 Push firmly until the cartridge snaps into
place (you should hear a click as the cartridge
engages the snap-in connector).
6 Press a drinking glass against the water dispenser
while checking for any leaks at the filter housing.
Any spurts and sputters that occur as the system
purges air out of the dispenser system are normal.
7 After filling one glass of water, continue flushing the
system for about four (4) minutes.
8 Turn On the ice maker.
9 Press and hold the Water Filter button on the Ice
& Water Dispenser control panel for three seconds.
When the display changes from “Red” to “Green,”
the status has been reset.
How do I remove the old filter to replace with a new one?
Diann for Model Number FFHS2611LBO
Answer DiAnn, here is the information located in your owners manual on how to change the water filter. Hope this helps!
1. Turn Off the ice maker power switch.
2. Remove the filter by pushing on the end/face of the filter.
3. Slide the old water filter cartridge straight out of the housing and discard it.
4. Unpackage the new filter cartridge. Using the alignment guide, slide it gently into the filter housing until it stops against the snap-in connector at the back of the housing.
5. Push firmly until the cartridge snaps into place (you should hear a click as the cartridge engages the snap-in connector).
6. Press a drinking glass against the water dispenser while checking for any leaks at the filter housing. Any spurts and sputters that occur as the system purges air out of the dispenser system are normal.
7. After filling one glass of water, continue flushing the system for about four (4) minutes.
8. Turn On the ice maker.
9. Press and hold the Water Filter button on the Ice & Water Dispenser control panel for three seconds. When the display changes from “Red” to “Green,” the status has been reset.