Where do I find instuctions to replace rear drum bearing and front felt guides? Thanks
Answer Hello Dirtfan. You will need to remove the top panel, by removing the screws on the back of the panel and sliding it off. Then remove the control panel assembly. Next you will need to remove the front panel of the dryer. There you will see the felt seal 134440200. This is a glue down part. To remove the tub, you will need to remove the belt, and lift up on the tub and slide it out the front of the machine. Then you can change out the rear bearing. Hope this helps.
1 person found this answer helpful.
The dryer is making a vibrating noise after a few minutes of running then gets louder??
You will want to check the bearing slides on the front of the drum to make sure that there is no damage to them. Make sure that all the felt is in place at the front of the dryer and if this checks ok then the issue would be with the rear bearings.
Hi - I just ordered the rear dryer bearing and I'm wondering how to properly disassemble the unit and replace the bearing. Thanks for your help!
Answer Hello Enev. 1. Open the door and remove the four screws holding the door to the hinges. Removing the access panel: The access panel is held to the upper side panels by two screws and two tabs. Remove the two screws and pull up and out to remove the panel. Opening the console: Disconnect pwer from the laundry center and remove the access panel. Remove the four screws, two on each side;holding the console to the dryer section side panels. Pull down and out on the console to release the tabs from the side panels. The console will now hang on the wires and the pressure switsh hose. Releasing the dryer belt; Remove the access panel. Push the idler pulley to the left and slip the belt off the motor pulley. Removing the dryer front panel: Open the console and remove the two screws holding the front panel to the side panels. Unplug the dryer door switch harness. Remove the four screws holding the front panel to the top and carefully pull the front panel forward. Removing the dryer drum: Disconnect the dryer drive belt from the motor. Raise drum to disengage the ball from the hitch and slide the drum out of the front. Note: You might need to remove the top of the dryer to be able to lift the drum out better. Now you can install the rear bearing kit.
Where do I find the model number?
Answer Hello Gertrude. Look inside the dryer door on the unit. It should be inside there.
How do I remove the old bearing from Frigidaire gas laundry center?
Answer Hello Uthanew,
I'm sorry but there are too many configurations to explain every one. If you could please re-post with the model number from your units' I.D. tag, we can look up the specific model you have in your home and give you accurate instructions. Thank you for your patience and understanding in this matter.
Drum makes banging noise once in rotation.
Answer Tom, depending on the model it could be the rollers or the rear bearing. We'll need your appliance model number to help troubleshoot and provide parts information. Please repost with the model number for further assistance. Thanks.