Plumber MIA with my regulator and cooktop manuals. Need to purchase replacement regulator. What model # do I need to purchase, and where? Top using natural gas.
Answer Don, the regulator is part number 318122707. Click on the part number provided to be linked to the parts page to view the parts information along with a handy repair video. Thanks!
Are there any adjustments that can be made to get a higher flame for the top burners?
Answer Hello Terry. No, it is not safe to adjust the flames. They should be blue to burn and cook clean. If they are to low, it could be to a faulty regulator or low gas supply to the unit.
I am using butane gas on my Frigidaire gas range, flame are yellow don't have access to natural gas, what part do I need to correct this problem. Thanks
Answer Hello Phil,
They are not the same! Otherwise the appliance would be rated and certified for use with both fuels! They have different BTU values and require different volumes of air for complete combustion.
To convert appliances, you MUST get conversion kits from the original manufacturer. They will give you a new rating plate which is their proof that the appliance is "certified" for use with that fuel. If you "Mcgyver" the appliance and try and convert it by just changing or drilling orifices etc, you will void the manufacturer's warranty. Also, the manufacturer will take no responsibility if the appliance hurts anyone or property is damaged because you have "altered" the appliance. Insurance companies will deny claims for the same reason.
On the appliance's rating plate you will find the model and serial number along with the manufacturer's contact information. Typically getting a conversion kit for natural gas to propane, or propane to natural gas is not too difficult. Butane may be a different story. You might end up having to replace the appliances altogether. Give them a call though. If they offer one and don't sell you one directly, they should be able to put you in touch with a dealer in your area who can.
Once you have the factory conversion kit installed by a qualified technician you are good to go!
I completed the LP gs conversion kit and is gas leaking out of the orifice on the regulator. Is my regulator shot?
Make sure that the orifice is in place properly but if still leaking then then yes the regulator would be bad.
The glow comes on, but oven will not light....
Answer Hello Betty. Test for 3.2-3.6 volts AC at the gas safety valve with the igniter turned on. If the voltage is there, you have a bad safety valve. If the voltage is low, you have a weak igniter and the igniter will need to be replaced. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
Everything lights, but the oven and igniter is not working.
Answer Hello Joe. Test for 3.2-3.6 volts AC at the gas safety valve with the igniter turned on. If the voltage is there, you have a bad safety valve. If the voltage is low, you have a weak igniter and the igniter will need to be replaced. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html