The water only comes out very hot no cold.
Answer Hello Jennifer. Check and make sure the screens are not clogged. If they are clear, you may need to change the water valve. Here is the part number for the model you provided 134371220. Hope this helps.
1 person found this answer helpful.
Hello, When I do a load of clothes the water just keeps going and overflows. We had to turn the washing machine off and the water. If we lower it to medium or small it still overflows. Soggy in Indiana help. What do we need to fix it?
Answer Hello Renna. If you can stop the water from entering the machine by turning off the timer or unplugging the unit, you will need to look for a bad pressure hose or replace the pressure switch. If the only way to shut off the water is at the shut off for the water hoses, you will need to replace the water valve in the unit.
Part number for inlet valve. Runs hot but not cold.
Answer Hello Dawn. We will need your model number to help you with this. Please call 1-877-477-7278 or post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx
Water keeps running even when machine off.
Answer Hello Wayne. Based on the information you provided, you need to order and replace the water valve on the unit.
As I am at the rear of the stack unit, what intake is hot and what one is cold?
In most cases if they are side by side the left will be hot and right will be cold. You will need to look at the cabinet of the unit for a marking of C for cold and H for hot next to the valve.
The washer pumps all the water out on the spin cycle and if clothing is immediately removed there is no problem.
After a period of time, I will find standing water in the drum. I don't think it can siphon back from the drain line but maybe. I'm wondering if the water fill valve may be leaking by.
This sounds more like an issue of the water valve allowing the water to flow through even though the unit is not calling for water. You will want to pull the hoses and check the screens on the water valve to make sure that there is no debris in them. If there is clean them out and recheck to see if water is still trickling in. If there is then the water valve 134190200 would need to be replaced.
My machine fills with water even when not in use. Water inlet valve or pressure switch? Thanks.
Answer Hello Bill. Based on the information you provided, the water valve is bad and will need to be replaced on the unit.
My washer won't stop filling with water. It overflows.
Answer Hello Alberto,
You need to start the machine. While it is filling, unplug it from the electrical power receptacle, (wall outlet). If the water continues to fill the machine, the water valve has failed and will require replacement to restore normal operation. If the water stops coming in, the issue is an electrical/electronic issue in the machine. This is normally the pressure switch, the timer has a set of contacts welded or stuck in the closed position, or a stuck relay on an electronic control board.
I can only wash on small or medium loads. On large, the water over flows out into floor. What part will I need?
Answer Hello Lea,
In the case of an over fill, you may not need any parts at all. If the tub end of the pressure switch hose is stopped up with lint and detergent residue, you can actually remove the pressure switch hose off of the pressure switch and blow through it. If it has resistance that "pops" away when you blew on it, it solved the problem. You could also have low water pressure to the water inlet valve. This can be caused by the screen in the water valve being stopped up with mineral deposits and sedimentation from the water supply. If cleaning the screens doesn't solve the problem, you may have to replace the pressure switch 134497500 or the water inlet valve 134190200 as one could be failing. To determine if the water valve is at fault, start the machine filling with water and unplug it. If the water goes off immediately, the pressure switch will be at fault. If the water continues to fill but starts filling more slowly until finally shutting off, the water inlet valve is the component at fault.