Washer fills and then nothing happens. I can hear a humming sound and the belt is intact could it be the motor? If so how could I test the motor beore buying one I may not need?
Answer Hi. Remove the front cover. With the belt removed, turn the main pulley back and forth to see if the transmission WH38X10002 and brake is free. If not then see if the upper spin bearing WH2X1198 at the tub and seal part # WH02X10383 has leaked and seized the bearing. Spin the motor part # WH20X10019 to see if the bearings are locked up. Then Start the washer in a low fill cycle. Is the motor humming now? It will if the clutch is locked up or bad bearings. Turn the unit off and remove the clutch clip and the clutch itself. Start the motor and see if it is free or is locked up. Thank You.
Please help. My washer will not spin nor wash. The last wash drained and that was it. Again, please help.
Answer Hi Michael. Your model starts with the letter "W"bse3120b2ww. Probably missing from the label. Open up the back control cover and see if you can see the control panel burnt up. This is the only information I can offer upon the information given. It is part # WH12X10224. I will be able to help with more info. Select a small load, let it fill . Does it start after the load has filled? Are the water valve screens plugged at the hose connections? Please double check your email info. if you prefer correspondence from it. Thank You.
My washer will wash the clothes, but will not run in the spin cycle. Do you think it is the motor?
Answer Hello WM. Check and make sure the drain pump is working properly. If so, make sure the lid switch WH12X10141 is working properly. If not, the unit will not spin out. Hope this helps.