Thanks for the install information on the mother board. Is the this OEM from GE wr55x10697?
Answer You're welcome Mitch! Our WR55X10956 is a direct OEM part to replace the original wr55x10697. Thanks!
1 person found this answer helpful.
How difficult is this to install? Will this come with any instructions? thanks
Answer Mitch, WR55X10956 does not seem to come with instructions. However, I have located an install question that has answered on our repair forum on the installation process of this part. Hope this helps you!
1 person found this answer helpful.
I have replaced the main board with new model WR55X10956 and now my led and door alarm dont work anymore, everything else is fine, could this be a bad board?
thank you in advance
You will want to double check all of the connections on the board to ensure that they are on terminals that will accept the number of pins for the connector. If this checks ok then if the leds worked previously then the board would be the issue.
I need to replace the main control board (as diagnosed by a professional repairman). Where is this located? You rate this replacement as pretty easy, but there is no video. Is there anything I need to know other than how to get to the control board?
Answer Hello Howard. There is a cover on the back of the refrigerator. Just disconnect the power and remove that cover. Then you can access and replace the main board in the unit. These are not hard to replace. I have a video to help you change the board. https://www.youtube.com/watch?v=sEGi8hwBv4M
The coil on the food side keeps freezing up is there a defroster on the fridge side?
Answer Hello Dan. No, there is not one. Dual Evaporator models, by design, create a high
humidity environment in the fresh food section.
Although this design improves the preservation of
certain refrigerated foods, the potential exists in some
units for an ice ball to form in the lower section of the
compartment due to excessively cold temperatures
and high humidity. The low temperatures are created
by gaps around the beverage center duct and along
the left side of the Custom Cool air handler cover.
These locations can be sealed and the temperature
improved using the service kit WR49X10180 (120V
heater). Refer to the
attached kit instructions for the proper repair method.
(Reposting with correct model). What is the difference between the main board wr55x10942 vs wr55x10943? Will the 942 work with my fridge it was ordered based upon a bad diagnostic technician?
Answer Hello Keith! We do not have the specs available to verify the difference between the two boards. According to your appliance model number given the correct main board listed for your appliance is part number WR55X11130. Thanks!
What is the difference between the main board wr55x10942 vs wr55x10943? Will the 942 work with my fridge it was ordered based upon a bad diagnostic technician?
Answer Keith, we do not have the specs available to verify the difference between the boards. The model number supplied, ZIC360N, is a partial model number. To verify which board is used on your refrigerator we'll need your full appliance model number. Please obtain this information and repost for further assistance. Thanks!
How to identify what mother board you have? Mine was replaced but does not function correctly. Inverter compressor will only run on low at all times. Both the inverter & mother board were replaced at same time also FF fan will only turn on for 15 sec.
The correct main control board for your unit is part number WR55X10956 and the correct inverter board for your unit is part number WR49X10283. You want to make sure that if there are instructions in the box for the parts that you follow the instructions or it may not work correctly.