I'm getting a burning smell coming from the dyer. Would that be the dryer belt going bad?
Answer Wayne, Yes, a worn out drive belt could produce a burn odor, but that's not too common. You're going to need to remove the front panel and the drum, vacuum out any accumulated lint, dust and debris, then check, clean, and lube the front drum glide WE03X10007 and rear drum bearing, to remove any excess "drag" on the drive system, and replace the drive belt WE12X10009.
i cant find an exact belt for my antique dryer. will this one work.
Answer Hello Janetta, we did not locate the model number you've supplied but we used the closest match. The belt we show to fit the 8200 series is WE12X49P. If you like to make sure this belt works, please recheck your model number and reply to our answer. Thanks!
The belt that I took off is numbered 134163400. Will this fit on my dryer?
Answer Hello Rudy! The replacement dryer belt used on your appliance is part number WE12X10009. This is the belt supplied from the manufacture. Thanks!
I need the drum belt #.
Answer Hello Russell. WE12X10009 is the belt part number for the model number you provided. Hope this helps.
What is the length and width of this belt?
Answer Hello Rob! We do not have the measurements of the belt WE12X10009. The model supplied DLV223GB4WW was not located, however, I was able to locate a model DVL223GB4WW (V and L switch around) and the belt called for this model is WE12X10009. Thanks.