24/7 Customer Support

CHECKOUT
Items in Cart:
Total
$0.00

Customer Questions and Answers for Water Filter Head and Tube Assembly by GE

  1. Our Price $51.54
    Compare At $69.75
    You Save $18.21
     
    • Part Number: AP3414864
    • MFG Part Number: WR17X11618
    • Made by: GE
    Add to Cart

Questions & Answers

For GE Water Filter Head and Tube Assembly (Part Number: AP3414864)

Ask a Question

Most Interesting  |  Latest Questions

During Hurricane Sandy I powered my house via a 3000w pure sine wave inverter conneced to (3) 12v deep cycle batteries in parallel for maximum runtime. the battery bank could be hooked up to my truck to keep the batteries charged. Anyway I had a Kill-a-watt monitoring device plugged into the refrigerator cord before the inverter powered it. The reading I received were, 135w when cooling and 585w when defrosting which is quite a draw on the batteries if the truck is not connected and running. What I would like to do is put a switch in the power feed side of the defrost heater lamp so I can turn it off if I have to power the refrigerator via the inverter again. I think I can do without defrost cycles until the power comes on for several days without effecting the refrigerator/freezers performance.Where does the current to the defrost heater come from, I cannot find a schematic for the electrical on my PSS25MGNAWW. I also changed sump pumps from a 9 Amp to a 3.8 Amp to lighten the load some more. Thanks!

John for Model Number PSS25MGNAWW

Answer

Was this helpful?

1 Answer

We replaced the water filter on our refrigerator a few months ago and ever since the water flow from the dispenser is good for a few seconds and then slows to a trickle. (Every now and then it has good flow long enough to fill a glass of water quickly). I took the filter out and put in the bypass plug and the result is the same. The icemaker seems to work just fine so I know water flow to the refrigerator must be ok. Any suggestions?

Mpowers for Model Number PSS26NGSB

Answer

Was this helpful?

1 Answer

There is a leak from the tubing at the point before it enters the water valve assebly. If I just change out the filter head assembly will it solve the problem of water leaking on the floor or could there be a problem with the water valve assembly that led to the leak in the tubing?

Laura for Model Number GSS25JSRFSS

Answer

Was this helpful?

1 Answer

I have replaced the water filter a couple times over the years without incident, but this time, when I removed the filter and installed the bypass, water started spewing from the filter head. I quickly replaced the bypass with the filter again but water continued to spew from the filter head. I can't see any explanation but had to just turn the water off (so now no ice either!) until I get a clue what could be wrong. Anyone? Thanks in advance.

Mark for Model Number GSH25VGRECC

Answer

Was this helpful?

1 Answer

I have replaced the water filter a couple times, but this time, after removing the filter and replacing with the filter bypass, water spews out of where the bypass is connected. When I remove the bypass and put the filter back on, water continues to spew. I'm pretty confident I put the bypass (and filter) in correctly and haven't had this problem in the past. Any ideas?

Markl for Model Number GSH25KGRE

Answer

Was this helpful?

1 Answer

The ice flap wouldn't close. I replaced it and replaced the water filter at the same time. The ice flap still wont open and close I was going to replace the solenoid and see if that would work. I replaced the water filter when I changed the ice flap. The water through the door was working fine after I replaced it but not no water is coming out. I can hear it humming but no water. After reading post I didn't fill the water filter with water before I put it in. Could this be the problem? What can I Do?

Jennifer E. for Model Number gss25vgmdww

Answer

Was this helpful?

1 Answer

Our freezer (side x side) seems to get warmer than what it should for a defrost cycle. There is water that drips off of the back left corner of the ice cube tray. It used to drip so that icicles would form on the back left side all the way down. Then I put a bowl under it to catch the water. Some stuff in the freezer seems to unthaw a little, but not alot. Some water bottles I have in there thaw out so there's a little water in them. Then it will seem to start working again. We also empty out the ice cubes when we see it starting to happen and turn off the ice maker. At the same time in the fridge, the veggie drawer freezes anything that's in there and sometimes the lower drawer as well. Then it starts working ok again. Usually lasts about a day or so. Any ideas?

Katie for Model Number GSS25TGPE

Answer

Was this helpful?

1 Answer

Ive got a GE profile side by side purchased in Jan of 09. Recently the water flow has been getting slow and has now stopped from the water dispenser. Ive changed the filter and still nothing. Ive unhooked and snaked all of the lines with trimmer string and have found no blockages, freezing etc. Even unhooked the blue quick connect ot the bottom of the freezer door and have no water flow. Ive removed the back access at the bottom of the fridge to access the valves. They are turning on, but there is no water coming to them from the filter. Ive tried the filter bypass and still have no flow. My question is, Ive now got the filter housing removed, if it is unhooked from the valve body with the line going into my sink, and the supply side is hooked up, with the filter installed, or filter bypass, should it flow water out the valve side line. I would think it should, but it does not. The check valve seems to be ok since the filter did fill with water and if I push it with a blunt object, it will flow. If I blow thru the valve side of the line, air travels freely thru the filter housing.... Im stumped and thirsty. Help! -Scott

Scott

Answer

Was this helpful?

1 Answer

I replaced my MWF water filter with a GE replacement. There were no issues with water pressure prior to changing the filter. I forgot to fill the filter with water before installing. When I use the water dispenser, there is a burst of high pressure water followed by an extremely light stream of water. Also there is a 'humming' noise. I have purged the system by running the water through the door for over 5 consecutive minutes and there is no increase in water pressure. The only difference in water pressure is when I over-tighten the filter. This leads me to believe that the rubber gaskets may not be creating a good seal - although the refrigerator is two years old. 1.) does this system include the entire assembly (looking for just the gaskets if it is the cause)? 2.) what is the cause?

Replaced Mwf Filter for Model Number GSS25WSTIS

Answer

Was this helpful?

1 Answer

Dear Sir, I have a GE Profile with which all works fine except I feel the water filter is being by passed with filter installed! When the unit was new I changed the filter when ever the flow from despenser was low. Now the flow never changes(flows the same has if the filter is new all the time). Is it possible for the filter head to be bypassing the filter with the filter installed? Any help appreciated.

Pete W. for Model Number PSS26MGPA

Answer

Was this helpful?

1 Answer

 

 
 
We are Safe, Secure, Dependable and Trusted
  • BizRate.com Customer Certified Site - Click to Verify