I just ordered a lanyard. Can you give me instructions on how to install this part? Mine was broken in to, and could not figure out how it was wrapped anround the pulley .
Answer Gary, Here you go : "When replacing the lanyard, place a nickel(coin) between the crank and plunger to set the proper tolerance. Hook loop of lanyard over end of crank. Thread lanyard behind the pulley and wind 1-1/2 times on left side. Rotate knurled wheel of pulley to firmly close duct door. Hold duct door closed, pull tension on lanyard and engage lanyard into notched hub of pulley in a zig-zag pattern. Wind lanyard around right side of pulley one full turn and hook end of lanyard into clip. Remove nickel(coin)and check operation. Make sure duct door closes fully." Thanks and Good Luck