Two days ago after a leaked seal that I replaced last year, my washer stopped spinning and agitating. It has no LED light on it. I cannot find any fuse anywhere. It fills up accurately to whatever level that it’s set at and drains after long hesitation (hesitation I guess equal to on the amount of time knob set for cleaning cloth). I changed the electronic board last year. I reset the washer by opening and closing the lid correctly again today. The belt and pulley can rotate bidirectional without any sound with correct belt tension. How can I rule out other causes except the drive motor (original WH20X10037 with LRA 6.1)? Also how do I check to see if enough voltage is getting to motor?
Answer Tony, you should have included an e mail address, we could have sent you all the information needed to diagnose and repair your washer. But, There is a fuse in the harness, located in the right rear corner of the cabinet, in the wire harness, it looks like a small black wire that is spliced into the red/white wire in the harness. The 120 VAC to the motor inverter board is supplied on the C2 connector, pin 5 red/black and pin 3 red/white wires, and pin 6 to pin 3 with the lid switch closed. You should find the tech data sheet located inside the control panel/console and should conduct the field service test, it'll help to direct you to the cause of the failure.
My motor does not run. I have sought out the error code but I see no flashing LED. I have seen many "how to" videos and know where the light is located. However, there is no flash.
With there being no light on the board, you will want to check the fuse that is in line of the harness that is in the right corner of the unit. Test the fuse for continuity. If there is no continuity then the fuse has failed and would need to be replaced.
My motor WH20X10058 has failed in my washer MD# wpre615oh1wt. I have another motor WH20X10057 will it work ?
Answer Hello Jason! No, we can not suggest WH20X10057 for your WPRE6150H1WT model. According to the model number you'll need to use part number WH20X10058 as the replacement motor. Thanks.
Is it fit to my washer's motor?
Answer Hello Kwanwoo. WH20X10058 is the correct motor for the unit.